Are you looking to hang large vinyl, sewn/hemmed banner type signs directly from walls? If so, we have the solution! This ingenious two piece, interlocking wedge-shaped banner hanger assembly makes it safe and simple to display and change out banners of almost any size directly from walls. Each assembly consists of one wall mount track and one banner hanger piece - both sold separately. Also requires our Plastic Banner Dowel Rod (sold separately) to display sewn/hemmed fabric or vinyl banners for a clean finished appearance. "C" channel bottom section also accepts various sign hanging options, such as plastic block end hooks or our line of ladderless clips. Simply prep the wall by screwing the wall mount track piece to the wall (mounting hardware included) and then fasten the "C" channel hanger piece onto the top edge of the banner and gravity does the rest. Signs hang approximately 1 inch offset from wall which creates a handsome dimensional effect. Removable and reusable - all safely from floor level. For use from ground level with our K-Stick® Ladderless Poles. Warning: Not recommended for outdoor use. Wall mount track must be firmly attached to wall. Patented.

• Wall mount track and "C" channel banner hanger piece are each sold separately
• Wall mount track has holes at 16" on center and comes with toggle screw anchors, stud screws and an instruction sheet
• Pre-drilling of holes for wall mount track is required (drill bit sold separately)
• Wall mount track piece is 3" tall x 1" wide
• "C" channel banner hanger piece accepts our line of Plastic Banner Dowel Rods (sold separately)
• "C" channel banner hanger piece is 1-3/4" tall x 2-1/4" wide
• Custom colors and lengths available
• White PVC material
• * For larger, heavier signs over 5 pounds it is possible to have two or more individuals, each with a K-Stick®, raise or lower simultaneously.